VanThanBK · Tube and Pipe Routing
Tube fabrication example
Release R001 · 3 part definitions · 13 tubes · 2026-10-05T03:20:25.040125+00:00
Dimensions in mm; angles in degrees. End A is the feed start in the bend table; End B is the tail. Print notch PDFs at 100% and check the 100 mm scale bar. Saved setups contain measured or operator-entered compensation; verify the first part on the actual machine.
Parts and manufacturing files
| Part / rev | Name / notes | OD × wall | Cut length | Qty | Bender setup | Files |
|---|
TP00001
r1 | Pipe 25x2-1
Mixed bend radii in one tube (40, 50, 70 mm): one die per tube is the norm.
CLR 40 mm < 2 x OD (25 mm): tight for rotary draw bending without a mandrel. | 25 × 2 mm | 908.26 mm
3 bends | 5 | Sample setup / r1
Steel | Bend CSV
Shop PDF
STEP |
TP00002
r1 | Pipe 25x2-1 (1)
| 25 × 2 mm | 1000.00 mm
0 bends | 4 | Sample setup / r1
Steel | Bend CSV
Shop PDF
STEP |
TP00003
r1 | Pipe 25x2-1 (2)
| 25 × 2 mm | 728.54 mm
1 bends | 4 | Sample setup / r1
Steel | Bend CSV
Shop PDF
STEP |
Changes since previous release
A changed source-body revision requests review even when the nominal centerline is unchanged. This is not a tolerance-based geometry-equivalence test.
| Part | Change | Before | After |
|---|
| TP00001 | added | | 1 |
| TP00002 | added | | 1 |
| TP00003 | added | | 1 |
| STOCK | settings | | 39b7b48dff10fb82c70bb3a4dd89a2c1daefac718349147383fff1d4000821b0 |
16 files listed in the manifest. Unregistered model bodies are outside this tube package. Register supported imported tubes with Recognize Tube.