VanThanBK · Tube and Pipe Routing
Tube end notch demo
Release R001 · 2 part definitions · 2 tubes · 2026-09-10T16:34:15.891288+00:00
Dimensions in mm; angles in degrees. End A is the feed start in the bend table; End B is the tail. Print notch PDFs at 100% and check the 100 mm scale bar. Saved setups contain measured or operator-entered compensation; verify the first part on the actual machine.
Parts and manufacturing files
| Part / rev | Name / notes | OD × wall | Cut length | Qty | Bender setup | Files |
|---|
TP00001
r1 | Branch - 25x2 - End B notch
| 25 × 2 mm | 200.00 mm
0 bends | 1 | Unassigned (zero compensation; steel density)
Steel density assumed | Bend CSV
Shop PDF
End B PDF · DXF |
TP00002
r1 | Main tube - 42x2
| 42 × 2 mm | 200.00 mm
0 bends | 1 | Unassigned (zero compensation; steel density)
Steel density assumed | Bend CSV
Shop PDF |
Changes since previous release
A changed source-body revision requests review even when the nominal centerline is unchanged. This is not a tolerance-based geometry-equivalence test.
| Part | Change | Before | After |
|---|
| TP00001 | added | | 1 |
| TP00002 | added | | 1 |
11 files listed in the manifest. Unregistered model bodies are outside this tube package. Register supported imported tubes with Recognize Tube.